Anyone know about the edge zero 2 trem?

The name says it all! Discuss Steve's studios, your studios and gear set-ups, amps and effects here. This is not for discussing guitars (Steve's or otherwise).
Post Reply
User avatar
kyle am I
Member
Member
Posts: 829
Joined: Fri Nov 11, 2011 7:19 pm

Delete
Last edited by kyle am I on Mon Apr 06, 2015 6:02 am, edited 1 time in total.
Jeries
Member
Member
Posts: 1535
Joined: Fri Jun 22, 2007 2:18 am

i dont think it's possible at all

either its a pop on, a screw in, or one that goes in and a nut above screws all the way in

they're def not interchangable

if you have a pop in one thats tight theres a tiny tiny allen wrench to adjust the tightness of the thing that holds the bar in- the way you get to it is pull the bar down and look behind the bridge theres a tiny area for a allen wrench on the right side under the bridge where the E B string are
User avatar
kyle am I
Member
Member
Posts: 829
Joined: Fri Nov 11, 2011 7:19 pm

Delete
Last edited by kyle am I on Mon Apr 06, 2015 6:03 am, edited 1 time in total.
Jeries
Member
Member
Posts: 1535
Joined: Fri Jun 22, 2007 2:18 am

i dont think so
i think the zero2 is a screw in... and the zero is a push in...

why do you ask? what's your concern?

from what i foudn online the Zeros just pop in and the edge II are screwed/threated in from the bar...

there are pros and cons to both- but not really interchangeably at all...
User avatar
kyle am I
Member
Member
Posts: 829
Joined: Fri Nov 11, 2011 7:19 pm

Delete
Last edited by kyle am I on Mon Apr 06, 2015 6:03 am, edited 1 time in total.
Jeries
Member
Member
Posts: 1535
Joined: Fri Jun 22, 2007 2:18 am

well a pop in would be WORSE than the screw in... you're better off with what you have than a pop in- they pop out all the time
so you're better off with what you have

also-

bend the bar down and look under/behind the bridge

if there's a screw/slot of an allen wrench under it to the right- that can tighten the bar when its inside- you may want to tighten it from the back and that might help it get unscrewed
User avatar
kyle am I
Member
Member
Posts: 829
Joined: Fri Nov 11, 2011 7:19 pm

Delete
Post Reply